Vision Multi Axis Specifiche Scaricare il pdf (Pagina 14)

14 Multi Axis Engraver Operating Manual

(Figure 3.4) The optional T-Slot table

Flat Engraving

Flat Objects - Initial Setup

When setting up to engrave flat material, you must first adjust the distance between the bottom of the spindle nose cone

and the material you are engraving. To do this, the following procedure is required:

Make sure that the light on the 4th Axis button on the Vision Series 3 Controller is red. If not, press the 4th axis

button and the spindle will move to the center position of the machine.

The distance between the bottom of the spindle and the clamping device must be adjusted to approximately 1 1/2“ as

shown in Figure 3.5 below.

(Figure 3.5) The height adjustment distance

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 40 41

Nessun commento

Vision Multi Axis Specifiche Pagina 14