Vision Cylindrical Manuale delle Istruzioni

1Table of ContentsSafety Instructions -------------------------------------------------- page 2Chapter 1Setting up the Vision Cylindrical System------

10Step 9.Start the Vision program. Using the mouse select FILE and open a NEW JOB.If you have never created a layout with the Vision program, refer to

11Attempting a new shape for the first timeIf you cannot determine the actual diameter of the object, select the closest object you are familiarwith a

12Hint: Always inspect an object before engraving. On inexpensive glass there may be a seam runningfrom top to bottom. Engraving over the seam may not

13Rub n’ BuffThis simple filler will add class to your engraved items. Many colors are available through your localcraft store. Once the item has been

14Figure 3.3•The wine bottle adapter maximum engraveable area for a large graphic or message or you can protect the label from thecoolant liquid. Simp

15•TROUBLESHOOTINGTrouble Condition Possible Cause Corrective MeasureSystem will not move to limits •Is the power cord connected? •Connect the power c

16• TROUBLESHOOTING (continued)Trouble Condition Possible Cause Corrective MeasureNo XYZ motion •Drives not on •Check LED Ind light, should be green.•

17Diamond CutterBrass Cutter Knob (with set screw)Spindle PulleyPointerNoseconeDiamond TipMicrometer(for depthadjustment)RetainerRingFigure 4.1•Clos

18LUBRICATIONRAILS• Lightly spray or wipe with 3 in 1—do not use grease. See figure 4.2.LEADSCREW• Lightly spray or wipe with silicone-based lubricant

19Number QTY Description100 1 Support L–Rack101 2 Screw–Adjust102 1 Shaft103 2 Bushing (not visable in picture)104 1 Pulley105 1 Carriage Adjustment K

2DisclaimerThe Vision Cylindrical Engraver Manual is Copyright ©1999 Vision Engraving & Routing Systems.All rights reserved. No part of this publi

20Number QTY Description121 1 Rack Front122 1 Head Stock Cap123 1 Drive Belt124 1 Pulley Support Bracket125 2 Head Locking Brackets126 2 Z-Axis Spring

21APPENDIX A ContactsAMACO(AMERICAN ART CLAY COMPANY, INC.)The maker of Rub ‘n Buff4717 West 16th StreetIndianapolis, IN 46222(800) 374-1600ANCHOR H

3CHAPTER 1 Unpacking and Setting Up YourNew Vision Cylindrical Engraver•Step 1Your Vision Cylindrical Engraver System has been packaged in 2 boxes. Yo

4•Step 4.Connect the glass engraver to the system control unit as shown in figure 1.2. If you already owna Phoenix engraver, connect the gray “table”

5Figure 1.2 • Connecting the system cables (Rear View)Figure 1.2a • The A/B Switchbox (RearView) for users of the Phoenix/VisionCylindrical ComboTo 11

6•Step 8.Now test the recirculating pump by hitting the AUX ON/OFF key on the control unit. Leave thekey in the red/green (AUX) position when finished

7In this chapter you will go through the easy steps to engrave a coffee mug. A piece has been suppliedfor you to experiment on. Don’t be disappointed

8Figure 2.1 • Top view of Vision Cylindrical Engraver with mug (note that mug handle is positionedto the front of the unitFigure 2.2 • Lowering the ca

9NOTE: Before moving on to the next step, make sure that the carriage is positioned to the left ofthe tailstock.Step 4.With one hand supporting the ca